"SERVICE" LIGHT

Discussion in 'General Motoring' started by Frank Matthews, Feb 28, 2005.

  1. Hi,

    yesterday 'cause I have to go through inspection I changed plugs, pcv,
    and oxygen sensor, and added a quart of oil... 10w-40 (usually calls for
    10w-30)... drove it out to mom's... fine... on the way home the
    "service" light comes on... all the connections seem good and it seems
    to run fine... is this just the result of the 10w-40 bumping up the oil
    pressure a bit and I should just change back to 10w-30 immediately? or
    more serious?

    ttyl

    Frank
     
    Frank Matthews, Feb 28, 2005
    #1
  2. Frank Matthews

    Bob Shuman Guest

    My opinion is that it is not likely your choice of oil. Something else is
    not quite right with whatever you did.
     
    Bob Shuman, Feb 28, 2005
    #2
  3. Frank Matthews

    C. E. White Guest

    The oil was not the casue. Mosty likely one of the other
    item you changes was the casue. I'd guess spark plugs. What
    type of car? Did you use the OE plugs, or decide to switch
    brands or types? If the service light was not on, why did
    you think you needed to do anything to pass inspection?

    Ed
     
    C. E. White, Feb 28, 2005
    #3
  4. Frank Matthews

    Joe Guest

    Hi,

    I have a 1994 Saturn SL2 with 122,000 miles. The service engine light came
    on my car today. The car feels like it's going to stall whenever I stop at a
    light.
    I put the car in neutral and give it some gas so it doesn't stall. Any
    ideas?

    Thanks,
    Joe
     
    Joe, Feb 28, 2005
    #4
  5. Frank Matthews

    Napalm Heart Guest

    Go to an Autozone and have them scan it.

     
    Napalm Heart, Mar 1, 2005
    #5
  6. Frank Matthews

    B. Peg Guest

    EGR valve.

    B~
     
    B. Peg, Mar 1, 2005
    #6
  7. Frank Matthews

    Joe Guest

    We have a winner. It was a clogged EGR valve.

    Thanks,
    Joe
     
    Joe, Mar 2, 2005
    #7
  8. Hmmm, I thought an EGR valve was closed at idle. A clogged EGR should then
    not be noticeable until acceleration. In fact the way I test my EGR is to
    take it off and cover the two holes with duct tape and temporarily reinstall
    it. then idle it see if there's any change.
    Van
     
    Van&Joan Hada, Mar 9, 2005
    #8
  9. Frank Matthews

    Napalm Heart Guest

    The EGR may not be able to close if it is clogged, i.e., stuck open
    because carbon deposits are holding it open. That's what happened on
    my '96 SL2.

    Ken
     
    Napalm Heart, Mar 10, 2005
    #9
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.